14 T RAKKER E URO 4/5 CLUTCH CHECKING AND ADJUSTING STOPS ON CLUTCH PEDAL (vehicles with ZF 9S/16S gearboxes) Figure 21 108470 Clutch stop Check the distance A between the pedal unit mount (1) and the end ofthe screw (2). It has to be 32.5 mm,turn thescrew appropriately if it is not. Pedal control valve stroke After adjusting the position of the bottom and top stop, adjust the travel of the piston of the pedal control valve. Take the clutch pedal (9) into contact with the bottom stop screw (2) and keep it in this position.
Press the button of the control valve (3) fully down and, keeping it pressed, position the angle bracket (4) so that between it and the button there is a distance of 0.5 q 1 mm. This is to prevent the pedal control valve from stopping the clutch pedal. Idle travel of clutch pedal Work the clutch pedal (9) to take the cap (6) into contact with the piston (5) of the master cylinder. In this condition, check the distance B between the clutch pedal (9) and the screw (7) that has to be 1 - 2 mm, turn the screw (7) appropriately if it is not.
The distance B corresponds to the clearance of 0.5 - 1 mm between the cap (6) and the piston (5) in the condition of the clutch pedal (9) in contact with the screw (7). Base - November 2006 Print 603.93.641