Iveco — Руководство по ремонту Iveco Trakker Euro 4/5 (EN)

22 GEARBOXESZF 16 S 1620 T.D. - 2220 T.D. - 2520 T.O. T RAKKER E URO 4/5  Figure 5 Working from under the vehicle: - Disconnect the pipes (1) and (2), previously freed from - Unscrew the nuts (5) and tie the clutch cylinder (6) to the clamps. the vehicle s chassis frame appropriately. - Undoing the side fasteners (8), take off the cross member (7). - Place a hydraulic jack equipped wit h the mount - Disconnect the propeller shaft (10) by undoing the 99370629 (1, SENZA CODICE) under the gearbox. screws (9) and tie it to the vehicle s chassis frame appropriately so it will not interfere with the removal of the gearbox. - Complete removing the gearbox bell fasteners (4).

- Afterwards, extract the gearbox from the engine by bringing it suitably back out ofthe space occupied by the exhaust pipe (3). Then lower the jack and take out the gearbox. Figure 6 45369 Refitting Carry out the operations performed for removal in reverse order and tighten the fixing nuts and screws to the required torque. NOTE For gearboxes with the intarder, proceed as follows: - Refit the heat exchanger to the inta rder, inserting new seals; fit the stud bolts and tighten the fixing screw and nuts to the required torque. - Connect the coolant pipes to the hea t exchanger and replenish the gearbox with the required amount of oil.

- Fill the engine cooling system as described in Section 2 Engine. 71752 Base November 2006 Print 603.93.641