22/1 T RAKKER E URO 4/5 GEARBOXESZF 16 S 1620 T.D. - 2220 T.D. - 2520 T.O. 530210 OVERHAULING THE GEARBOX Disassembly Figure 6/2 NOTE Wash the assembly thoroughly before overhauling. The specific and/or general tools must be used in the way for which they were designed. To facilitate assembly, put the removed parts away on the specific tray in their order of removal. Upon assembly, the following must always be replaced with new parts: the gaskets and seals, spring pins, safety plates and springs. Nuts and screws must be tightened to the prescribed torque with their thread dry and degreased. Keep to the specific regulations when disposing of lubricant and detergents.
61227 Unscrew the fitting (2) and disconnect the air pipe (3) from the distributor (4). NOTE There follows a description of the operations for overhauling the ZF 16 S 2520 gearbox that, unless stated otherwise, hold for the ZF 16 S 1920/2220/ 2320 gearboxes too. Figure 6/3 Fit the supporting brackets 99371031 to the assembly. Using ropes with hooks and a movable lift, position the assembly on the rotary stand 99322205 together with the mount 99322225. 530220 Servoshift gear box Removal Figure 6/1 61257 Unscrew the screws (1, Figure 6/2) and disconnect the servoshift (1) from the gearbox (2). Take out the push rod (3) with the spring (4).
Figure 6/4 Note down the assembly position of the pipes (3 and 4) and disconnect them from the gearbox (5) by unscrewing the fittings (2 and 6) together with the washers. Unscrew the fixing screws (1) and remove the gearbox (5) together with the servoshift from the gearbox. 61226 61228 Mark the assembly position of the lever (7) on the rod (6). Loosen the nut (5) and remove the lever (7) from the rod (6). Extract the cup (8). Remove: - the valve (3) after taking out the screws (4). - the switches (1 and 9) with their washers and push rods NOTE The servoshift cannot be overhauled. Replace it if you find any trouble.
Refitting For refitting, carry out the steps described for removal in reverse order, fitting new seals and tightening the fixing screws (1) and fittings (2 and 6) to the required torque. (2 and 10). - the plug (13) with its washer, the spring (12) and the push rod (11). Print 603.93.641/A Revi - June 2007