F2B ENGINE 43 T RAKKER E URO 4/5 543422 ELECTRO-MAGNETIC FAN DRIVE REPLACEMENT Removal Figure 17 87199 Tocut off the batteries, removethe electric wires or openthe main switch. Remove the bumper fastening screws. Move the bumper away from its respec tive supporting brackets, then place it, without subjecting the electric cables and the headlamp wiper pipe (if any) under tension, on a suitable stand soas to subsequently allow the cab to be tilted. Lift the radiator grill, then tilt the cab. Go under the vehicle and remove the plug (15) from the radiator (16) and drain the coolant fluid in the appropriate container.
Remove the clip (14) and disconnect the radiator (16) sleeve (13). On the engine compartment left-hand side, remove the screws (12) and the heat guard (11). Take off the screws and disconnect the air conveyor (8) climate control pipes (5). Slacken the sleeve fastening clamp (7)fromtheintercooler (6) radiator. Remove the air conveyor (8) fastening screws (9) to the support bracket (10). Remove thescrew (19) and detach the electric wire (18) from the air conveyor (8). Remove the clamp (20) and detach the air conveyor (8) together with the sleeve (7) from the turbocharger (17) and from the intercooler radiator (6).
Drive in the suitable self-threading screw in the pin hole (3) taking care to partially take off and finally remove with a screwdriver the upper clip (2) fastening the fan air conveyor (4) to radiator guard (1). Remove the lower clip in the same way. Remove the two radiator support fastening screws to the chassis. Print 603.93.641 Base - November 2006