To Access the PROGRAM Mode: from the run mode 1 2 e.g. rate display last parameter from previous PROGRAM session e.g. P005 Master Reset Prior to programming, balancing and calibration, a master reset of the BW100 should be done. Refer to Parameter P999 on page 64. Load Cell Balancing If you are operating a two load cell belt scale, it is recommended that the load cells be balanced electronically prior to initial programming and calibration, or after either or both load cells have been reinstalled or replaced. Note: Unbalanced load cells adversely affect the performance of your belt conveyor weighing system.
Load Cell ’A’ Load Cell ’B’ test weight bar Start Up belt travel typical dual load cell scale With the conveyor stopped and locked out, lift the belt off the weighing idlers. 7ML19985DJ01 Milltronics BW100 - INSTRUCTION MANUAL Page 21