Q5686A/Q5687A DISASSEMBLY/ASSEMBLY 6. Fasten the wire bracket [1] tentatively to the up/ down stay [2] with 2 screws [3]. Note: • Be sure to set the up/down wire [4] with the shorter section [5] up and the longer section [2] [6] [6] down. [4] [1] [5] [3] 7. With a new up/down wire fastened to the wire end [2] of the up/down pulley L [1], wind the III DIS./ASSEMBLY wire a little less than 5 turns from inside toward outside around the pulley without getting loos- ened and set the up/down pulley L [1] to the shaft so that it is in tune with the pin [3]. [1] [3] [2] 8.
After putting the up/down wire on the up/down pulley U [1], wind it 2 turns from inside toward outside around the up/down pulley L [2] without getting loosened and fasten it to the wire end [1] [3]. [3] [2] 3-15