A90 series Inverter User Guide 4.2.2 User-Defined Mode (--U--) The Function group F11 can be used to set the shortcuts of 32 parameters. When entering group F11 from the All menu mode, The default display is U00.00 for the first time to enter F11.00, which means that the default parameter of F11.00 is F00.00; at this time, the lowest cursor bit flickers and user may set any parameter number; press to save setting; when entering the User-defined mode, only Selected parameters will be shown. For instance, set F11.00 =U00.07 and set F11.01 =U00.09, i.e., F11.00 and F11.01 are respectively defined as the shortcut of F00.07 and F00.09. The letters U and F are used for distinguishing.
U means that the function parameter is user defined. See Figure 4–4 for details. Flash bit Flash bit Flash bit Flash bit Flash bit Flash bit Flash bit Flash bit Press under the User-defined mode to enter the level 2, which only displays 32 Figure 4-4 Example of User-Defined Mode Setting user-defined parameter selected by F11. After the codes are defined in F11, we select and enter the user-defined mode and we can see that the first parameter is F00.07 defined by F11.00 and the second parameter is F00.09 defined by F11.01 until F11.31. There are 32 parameters. Only 32 function parameters can be displayed by entering this mode.
Changing the function parameters under the level 3 has the same effect as that under the All menu mode. In the User-defined mode, the level 2 operates the Up key or the Down key,Switching order F11.00 custom parameter to F11.31 custom parameter. Press in the level 2 and cursor will not shift. After entering the level 3 by pressing permitted for change. Changing the parameter in the level 3 has the same effect as in each menu , the lowest position of cursor will flash if current status of corresponding parameter is mode. 24