A90 series Inverter User Guide 4.2.3 Non-factory defaults (--C--) Press under this mode to enter the Level 2, which displays the first parameter that starts from F00.00 and differs from the default value. The key is disabled under this mode; Using Up/Down key to switch previous/next non-factory default of the parameter. The lowest position of cursor will flash if current parameter is permitted for change. The method of changing parameters is the same as that in the Level 3 under all menu mode; after changing, press to save the change and enter the next non-factory default parameter.
are not factory defaults, then when entering the non-factory defaults mode, the first displayed For instance, if we set F00.03 as 1 and set F00.07 as 40.00 under the all menu mode, which value is F00.03; Operate the UP key will switch to F00.07, Operation of the down keywill return F00.03,The following figure will be shown: Figure 4-5 Modification of parameter in non-factory value mode 4.2.4 Fault information display mode (-- F--) Flash bit Flash bit Fault information display mode, press the ENTER key to enter the level 2, then can display the parameter only F19 group fault record group, user direct access to fault record information.
In this mode, when in the level 2, Use the Up key or the Down key to switch, and the shift key is invalid. 4.3 Fault monitoring In the event of a fault, directly press the shift key can be switched among the fault code, the fault output frequency, the fault output current, the fault bus voltage, and the fault operation status. 4.4 Operation monitoring A90 allows the selection of any parameter you want to see in F12.33- F12.37. At level 0 ， press the shift key to switch the sequence monitoring parameters of each function code as F12.33 ~ F12.37 to learn more about current status. 4.5 Function of M.K. The default action of is jog forward.The function can be changed by the parameter F12.00.
4.6 Run/Stop When the parameter is set, press the RUN key ， The inverter can run normally ； Press the STOP / RESET key ， the Inverter stop 。 25