CandidatePointsCount CandidatePointsCount VPARAMETER 5300 Sets the number of candidate locations where the tool tries to evaluate the sharpness. When the tool is executed, it scans the region of interest and identifies a number of candidate locations (equal to CandidatePointsCount) where the local standard deviation is the highest. The local sharpness is then evaluated at each candidate location that has a local standard deviation above the StandardDeviationThreshold property. The number of locations where the sharpness is actually measured is returned by the MeasurementPointsCount property.
When the AutomaticCandidateCountEnabled property is True, the number of candidate measurement points is automatically determined according to the size of the region of interest and CandidatePointsCount. Syntax Micro V+ VPARAMETER (sequence_id, tool_id, 5300, index_id, object_id) = value value = VPARAMETER (sequence_id, tool_id, 5300, index_id, object_id) V+ VPARAMETER (sequence_id, tool_id, 5300, index_id, object_id) $ip = value value = VPARAMETER ($ip, sequence_id, tool_id, 5300, index_id, object_id) Type Long Range Minimum: Greater than 0. Maximum: 32767 Parameters ACE Reference Guide, 18317-000 Rev A Page 149 $ip IP address of the vision server. Applies to V+ syntax only.
Uses standard IP address format, for example: 192.168.1.120.