Downloaded from https://www.everyspec.com ADS-65A-HDBK 4.8.3.15 Display, Charge Coupled Devices and Camera Analysis Verify Design of Displays, Charge Coupled Devices, and Cameras Standard: Evaluate system performance parameters that are necessary to evaluate image quality. Compliance: Analysis should be conducted on displays, charge coupled devices, and cameras to evaluate system performance parameters that are necessary to evaluate image quality . Displays, should be evaluated in accordance with section 5.4.1 and charge coupled devices should be evaluated per applicable requirements of section 5.5.3. Cameras should be evaluated per applicable requirements of section 5.5.2 through 5.5.6.
4.8.3.16 Thermal Loading Verify the Thermal Loading of the Sensor System Standard: The thermal load of the sensor system should not adversely affect the aircraft. Compliance: A thermal loading analysis will be conducted to verify the sensor system’s thermal loading does not adversely affect the aircraft, equipment, or crew members. Analysis should also cover the aircraft’s thermal effects on the sensor and the temperatures found in the avionics bays. 5.0 DETAILED GUIDANCE 5.1 Built in Test (BIT) Verify functioning of any Built-in Test (BIT) Standard: BIT will perform failure detection and failure isolation. Compliance: Verify the BIT will perform failure detection and failure isolation.
A BIT may be continuous, automatic, or initiated as required. 5.2 Gimbal Stop Evaluation Verify the Gimbal Stops Performance Standard: Mechanical, electrical, and software stops prevent damage to the sensor system and prevent hazards due to lasing of the aircraft and crew. Compliance: An evaluation of the performance of the gimbal stops should be conducted. 17