A RMING A SPLIT SYSTEM As explained at the beginning of the chapter “Using a split system,” a split system can be programmed to show two different standby message displays, and two different ‘selection’ messages after entering your code. The instructions below use the displays “Time/Date” and “Area [ number ] armed.” If your code lets you access more than one security area, you can select one of them to arm. 1. Go to the keypad. The current date and time are displayed. An example is shown. TUE 23 APR 07.40 2. Press the key 0 and then enter your code. A ‘*’ appears in the display for every key you press. Use the 0 key to cancel an incorrect entry and to restart a new entry of the code.
Enter Code 0 + code Enter Code **** In this example, areas 1 and 2 are disarmed. Area 1 Disarmed Area 2 Disarmed You have a few seconds to enter the number of the area you want to arm. Enter Area No. 3. Enter the area number (in this example it is 1). 1 Arm Menu 4. Press the Accept key. ! Normal Set 5. Press the Accept key again. ! If you want to exclude zones in the area (open zones), press the arrow key ( ↑ ). This feature is explained in the section “Arming a system which has open zones.” Otherwise do nothing: the message ‘Area 1 Arming’ appears automatically. Normal Set " Area 1 Arming Area 1 is arming. If programmed, the buzzer for the system will begin.
Beeeep Leave Now Area 1 Armed Area 2 Disarmed Enter Area No. 6. If you also want to arm area 2, enter the number 2 into the keypad. 2 Arm Menu Page 12 User Manual for CD72/95/15003