7. Press the Accept key again. ! Normal Set ! Normal Set " Area 2 is arming. If programmed, the buzzer for the area will begin. Area 2 Arming Beeeep You must exit the protected area by the designated exit route. Leave Now Area 1 Armed Both areas are now armed. Area 2 Armed Enter Area No. TUE 23 APR 07.41 A RMING A SPLIT SYSTEM WITH OPEN ZONES When arming (switching on) the alarm, you may get the message ‘Open Zone(s)’ along with a list of the zones in the premises which have not yet been closed. You should close these zones and then retry arming the alarm.
However, occasionally you may not be able to close an open zone because, for example, a door lock or magnetic contact may be malfunctioning. You can then exclude this open zone from the system (called inhibiting a zone). A split system lets you control open zones in specific areas of the premises. Only use this exclusion option when absolutely necessary as any inhibiting of zones will reduce the security level of your system. Although you can exclude an open zone when the tamper alarm has been triggered (identified by the letter ‘T’ in front of the open zone listed), you will not be able to arm the system until the tamper alarm has been rectified.
As explained in section “Arming a split system,” a split system can be programmed to have two different standby message displays, that is the message you see when you approach the keypad, and two different messages immediately after entering your code into the keypad. The instructions below use the displays “Time/Date” and “Area [ number ] armed.” If your code lets you access more than one security area, you can select one of them to arm. 1. Go to the keypad. The current day, date and time are displayed. An example is shown. TUE 23 APR 08.21 2. Press the key 0 and then enter your code. A ‘*’ appears in the display for every key you press.
Use the 0 key to cancel an incorrect entry and to restart a new entry of the code. Enter Code User Manual for CD72/95/15003 Page 13