Chapter 9 Troubleshooting 9_ 9-39 Error Code Description Corrective action 16#001A The contents of the system backup file (.dup file) are incorrect. Create the system backup file again. 16#0033 The communication setting of COM1 is incorrect. (SM9) 1. Check the program and the related special data registers. 2. Set the communication port parameter for the CPU module in HWCONFIG again. 16#0034 The setting of the station address of COM1 is incorrect. (SM9) 1. Check the program and the related special data registers. 2. Set the communication port parameter for the CPU module in HWCONFIG again. 16#0035 The setting of the communication type of COM1 is incorrect. (SM9) 1.
Check the program and the related special data registers. 2. Set the communication port parameter for the CPU module in HWCONFIG again. 16#0038 The communication setting of COM2 is incorrect. (SM9) 1. Check the program and the related special data registers. 2. Set the communication port parameter for the CPU module in HWCONFIG again. 16#0039 The setting of the station address of COM2 is incorrect. (SM9) 1. Check the program and the related special data registers. 2. Set the communication port parameter for the CPU module in HWCONFIG again. 16#003A The setting of the communication type of COM2 is incorrect. (SM9) 1. Check the program and the related special data registers. 2.
Set the communication port parameter for the CPU module in HWCONFIG again. 16#0066 An error occurs when the system is backed up. 1. Check whether the memory card is normal, and whether the capacity of the memory card is large enough. 2. Retry the backup procedure. If the error still occurs, please contact the factory. 16#0067 The size of the PLC parameters restored exceeds the size of the PLC parameters of the CPU module. The error code is appeared to indicate alarm only. 16#2000 There is no END in the program in the PLC. (SM5) 1. Compile the program again, and download the program again. 2. Reinstall ISPSoft, compile the program again, and download the program again.
16#2001 The program is incorrect. There is a syntax error. Check the program, compile the program again, and download the program again.