AL-M320DN/AL-M310DN/AL-M220DN User's Guide Important Instructions ❏ When connecting this product to a computer or other device with a cable, ensure the correct orientation of the connectors. Each connector has only one correct orientation. Inserting a connector in the wrong orientation may damage both devices connected by the cable. ❏ Do not use printer in a damp environment. ❏ Avoid locations that are subject to direct sunlight, excessive heat, moisture, oil vapor, or dust. ❏ Avoid locations that are subject to the air coming directly from an air conditioner. ❏ Use only optional products, such as the paper cassette units and the printer stand, produced specifically for this product.
Using options produced for other products may cause the product to fall over and injure someone. ❏ Do not place the printer on an unstable surface. ❏ Slots and openings in the cabinet and the back or bottom are provided for ventilation. Do not block or cover them. Do not put the printer on a bed, sofa, rug, or other similar surface or in a built-in installation unless proper ventilation is provided. Finding the place for the printer When relocating the printer, always choose a location that has adequate space for easy operation and maintenance. Use the following illustration as a guide for the amount of space required around the printer to ensure smooth operation.
❏ Keep the entire computer and printer system away from potential sources of interference, such as loudspeakers or the base units of cordless telephones. ❏ Leave adequate room around the printer to allow for sufficient ventilation. Note: Figures are rounded off to the nearest whole number. Using the printer ❏ Some of the symbols used on your printer are to ensure safety and proper use of the printer. Visit the following web site to learn the meaning of the symbols: http://support.epson.net/symbols/ Be careful not to touch the fuser, which is marked with a caution label, or the surrounding areas. If the printer has been in use, the fuser and the surrounding areas may be very hot.
If you must touch one of these areas, wait 40 minutes to allow the heat to subside before doing so. Be careful of the sharp edges. Do not touch the sharp edges. It may hurt your fingers, etc. In addition to space considerations, always heed the following precautions when finding a place to locate the printer: ❏ Place the printer near an electrical outlet where you can easily plug in and unplug the power cord. ❏ Do not put your printer where the cord will be stepped on. 8 a 20 cm d 50 cm b 30 cm e 30 cm c 30 cm