8. Mini-USB Port: This port is for you to connect to the PC to transfer the diagnostic or battery test report. (See Figure 2.1.3) ● There is no built-in battery inside the AL500B, so no need to charge it. The Mini-USB port is only for data transfer. Figure 2.1.3 9. Diagnostic Cable with DB15 Female Connector & 16-pin OBD-II Connector . (See Figure 2.1.4) ● This connects to the DB15 Male connector at the top of the ArtiLink500B. The other end connects to the OBD port. Figure 2.1.4 10.
Battery Test Cable with OBD-II Female Connector & ● After the OBD-II diagnostic cable is properly connected to the AL500B, connect this cable to the OBD- II diagnostic cable, and the clamps to the battery terminals to test the vehicle battery. Battery Clamps. (See Figure 2.1.5) EN | 9