Delta Electronics — 6.26.2 Explanation of High-speed Output Instructions

Chapter 6 Applied Instructions 7. There is no limit on the number of times you can execute this instruction, but during execution, the designated high speed axis cannot be occupied by any other instruction, and the other instruction is not executed. The following graphic shows the output timing diagram. Speed D 2 = OFF D 2 = ON S 3 x S 4 D 1 +1 = OFF S 1 S 2 Position D 1 +1 = ON S 3 x S 4 D 2 = OFF D 2 = ON Example When M0 is ON, the DPPGB instruction starts to move back and forth between the target positions that are calculated 6_ from the two relative target positions specified by S 1 and S 2, at the actual target speed of 8500 Hz (5000*1.7). Y0.0 is the output point.

Y0.1=OFF means the positive direction. 6-881