Delta Electronics — 6.26.2 Explanation of High-speed Output Instructions

AS Series Programming Manual Explanation 1. This instruction is available for PLC with FW V1.04.90 (V1.04.90 included) or later. 2. This instruction causes the machine to return to the zero point. The range of the target frequency ( TFreq ) for zero return is between 1 Hz–200 kHz. The JOG frequency ( JFreq ) should be less than the target frequency ( TFreq ). The JOG frequency ( JFreq ) is the start frequency. If the target frequency ( TFreq ) is less than ( JFreq ), the target frequency ( TFreq ) is automatically revised processed as equal to ( JFreq ) . 3. Do not change the operands DOG, NL, Pulse, or Dir during instruction execution.

The input point for DOG and NL is suggested to use the 16 high-speed input points X0.0–X0.15. They will not be affected by PLC instruction scan time. If you use X1.0 successive input points or M devices, they will be affected by the PLC instruction scan time. 4. See the below descriptions for DOG, NL and Dir. 5. See the below SR and SM table for pulse outputting. _6 6-886 DOG point You can use X or M device but do NOT choose the same input point for different axis. When the DOG point uses X0.0–X0.15 for inputs, go to HWCONFIG to set up the filtering time for the inputs if the switch starts to rattle.

NL point You can use X or M device but do NOT choose the same input point for different axis. Dir contact You can use Y or M device but do NOT choose the same input point for different axis. Pulse output points Y0.0 Y0.2 Y0.4 Y0.6 Y0.8 Y0.10 Setting up the time for SR640 SR642 SR644 SR646 SR648 SR650 directional outputting goes first before pulse outputting (unit:

1 ms) Busy flag SM460 SM480 SM500 SM520 SM540 SM560 Completion flag SM461 SM481 SM501 SM521 SM541 SM561 Present output position SR460 SR461 SR480 SR481 SR500 SR501 SR520 SR521 SR540 SR541 SR560 SR561 Pulse output points Y0.1 Y0.3 Y0.5 Y0.7 Y0.9 Y0.11 Setting up the time for SR641 SR643 SR645 SR647 SR649 SR651 directional outputting goes first before pulse outputting (unit: 1 ms) Busy flag SM472 SM492 SM512 SM532 SM552 SM572