Delta Electronics — 6.19.2 Explanation of Communication Instructions

AS Series Programming Manual ASCII mode You do not need to convert the ASCII codes, and they are all expressed in 16# values.  AS sends the communication command: “ : 01 03 10 20 00 08 C4 CR LF”.  AS receives the communication command: “ : 01 03 10 12 34 56 78 11 22 33 44 55 66 77 88 99 AA BB CC AA CR LF”. RTU mode  AS sends the communication command: “01 03 10 20 00 08 41 06”.  AS receives the communication command: “01 03 10 12 34 56 78 11 22 33 44 55 66 77 88 99 AA BB CC 90 FE”. If the format is correct, SM100 is ON.  The response messages from the DVP-ES2 is stored in registers D10 to D17.  The following table lists the values in D10–D17. 4.

After the receiving the data sent back from the DVP-ES2, the PLC confirms the data format sent back from _6 DVP-ES2 and determines if it is correct. If no error occurs in the format, the corresponding special flags SM100 are ON; if not SM102 is ON. 6-554 Device D10 D11 D12 D13 D14 D15 D16 D17 Value (16#) 1234 5678 1122 3344 5566 7788 99AA BBCC