Delta Electronics — 6.19.2 Explanation of Communication Instructions

Chapter 6 Applied Instructions The PLC sets the flag to ON when the reading success flag indicates that receiving data is complete and the data checked are correct. If an error occurs in receiving data or a communication timeout occurs, the error flag is set to ON refer to the error codes). The PLC does not reset any of the reading success or error flags to OFF in the data exchange since the reading success flag and error flag of every connection number are not ON simultaneously. 9. The following table describes the SR (only-read registers) in the data exchange function. 6_ 6-599 SM928–SM959 R Error flags for data exchange connections 1–32 SM No.

Attribute Explanation for Function Card 1 data exchange parameters SM1710 R/W Enables data exchange SM1712 ~ SM1743 R/W Enables data exchange connections 1–32 SM1744 ~ SM1775 R Reading success for data exchange connections 1–32 SM1776 ~ SM1807 R Error flags for data exchange connections 1–32 SM No. Attribute Explanation for Function Card 2 data exchange parameters SM1822 R/W Enables data exchange SM1824 ~ SM1855 R/W Enables data exchange connections 1–32 SM1856 ~ SM1887 R Reading success for data exchange connections 1–32 SM1888 ~ SM1919 R Error flags for data exchange connections 1–32 SR No.

Description SR1335 Cycle of the actual connections 1–32 in the COM1 data exchange SR1336 Cyclic connection number in the current COM1 data exchange SR1340–SR1371 Error codes of the connections 1–32 in the COM1 data exchange SR1375 Cycle of the actual connections 1–32 in the COM2 data exchange SR1376 Cyclic connection number in the current COM2 data exchange SR1380–SR1411 Error codes for connections 1–32 in the COM2 data exchange SR1435 Cycle of the actual connections 1–32 in the Function Card 1 data exchange SR1436 Cyclic connection number in the current Function Card 1 data exchange SR1440 ~ SR1471 Error codes of the connections 1–32 in the Function Card 1 data exchange SR1475 Cycle of the actual connections 1–32 in the Function Card 2 data exchange SR1476 Cyclic connection number in the current Function Card 2 data exchange SR1480 ~ SR1511 Error codes of the connections 1–32 in the Function Card 2 data exchange