Inspection This tool has a modified configuration section. Each inspection filter is displayed in this sec- tion: Inspection Category with one Filter, shown in Configuration Section Categories The purpose of categories is to sort instances based on the filters in each category. An instance is put into the first category that it passes the filters for. For each instance, cat- egories are evaluated starting with the category listed at the top of the Configuration section. Each category has a name and an operator associated with it. The operator (AND or OR) is applied to all of the filters within the category to determine which instances are put in that category.
The operator associated with a category is displayed in the Description field of the Configuration section, shown in the preceding figure. ACEUser's Guide, 3.6.x, 18316-000 Rev A Page 538 Object Definition Show Results Graphics Specifies if the graphics are drawn in the Vision Window. Advanced Properties Image and Filter Logging Logging mode when the Inspection fails. Results Logging Specifies if a results log will be generated. A csv extension generates csv format. Move selected category up or down to determine the order in which they will be used to sort instances.
Greyed-out when not applicable (top and bottom) Category Add a new category Filter Add a new filter and open the filter editor (a category or filter must be selected) Delete Delete the selected category or filter (deleting a category deletes all of its filters) Edit Edit the selected category or filter (double-clicking also opens the appro- priate editor)