omron — Editor Parameters

Editor Parameters Control Menu View Belt Encoders Displays a wizard used to view the operation of the belt encoder. Test Latch Signal Displays a wizard used to view the operation of the encoder latch sig- nal. For details on these menu items, see Viewing Belt Encoders and Testing Latches on page 818. Editor Parameters The middle portion of the Belt Editor contains the editor parameters. These are used to configure various settings on the selected conveyor belt. The Belt Editor parameters are described below. Belt Control Group The Belt Control group is used to specify various controls for a conveyor belt, as follows:

ACE User's Guide, 3.6.x, 18316-000 Rev A Page 813 Item Description Active Control When selected, enables control of the conveyor belt from the specified Adept con- troller. When emulation mode is enabled: For the belts that do not have Active Control enabled: l When the process starts, start all belts l When the process stops, stop all belts l For the belts that have Active Control enabled: l When the process stops, stop all belts that are in On/Off control l mode. See the description of On/Off mode in this table. NOTE:

For emulation-mode calibrations, the belt controls in the Calibration wizards will allow you to operate the belt, even when the Active Control option of the Belt object is not enabled. For more details on emulation mode, see Emulation Mode on page 1089. Controller Select an Adept controller to use for controlling the conveyor belt. Use the list icon ( ) to display the list of available controllers. If there is only one controller available in the ACE workspace, it will be automatically selected for you. On/Off Enter the digital I/O signal number to use for starting and stopping the conveyor belt. When the signal is on, the conveyor belt is moving. Click the signal icon ( /