3.3. Operation Operation Precautionary measures during machine travel If the machine is driven over long routes at a high speed and without having adapted the tyre pressure, the tyres will become very hot. This leads to premature wear and tear of the tyres which should be avoided if possible. Adhere to the following instructions if you must drive the machine over a long distance: Perform all pre-start checks before starting to drive (see chapter "3.3.1. Pre-start checks" on page 3-34). Fix supplementary hand tools before starting to drive. The required tyre pressure, the driving speed or the tyre type may vary depending on the condition or structure of the road o be used.
Contact the responsible Komatsu trader or the tyre dealer to obtain the required information. The required tyre pressure can be found in the tyres and tyre pressure table in chapter "3.3.16. Tyre handling" on page 3-77. Check the tyre pressure with the tyres being cold before driving. Lower the work unit to its transport position and move it completely to its rear limit stop position. Always drive with empty bucket or empty forklift truck attachment. Adhere to the valid motor vehicle traffic regulations and drive very careful. Make sure that the working lights and the warning beacon are turned off while driving on public roads. Take a 30 minute break after driving for one hour.
Check the tyres and all particularly strained parts during driving on pub lic roads whether they are still fully functioning or damaged. 3-68 WA90-5 – VEAM270100