Operation 3.3. Operation 3.3.11. Adjusting the position of the work equipment Selecting a work unit Refer to chapter "1.7. CE-conforming equipment" on page 1-20 for information on the work units registered. Picking up the work unit (except multi-purpose bucket) Connect the multi-purpose bucket as described in section "Pick ing up the multi-purpose bucket" on page 3-72. 1. Make sure that the change-over lever for the additional con trol unit is in position '2' (fig. 75_160). 2. Start the engine. 2 1 75_160 3. Unlock the quick-change unit by setting the control lever for special equipment into position ‘1’ (fig. G0065018.eps). 4.
Lift the boom a slightly by setting the multi-function lever into position ‘H’ (fig. G0065021.eps). 5. Tilt the quick-change unit a slightly to the front by setting the multi-function lever into position ‘A’ (fig. G0065021.eps) WA90-5 – VEAM270100 3-69