3.3. Operation Operation 6. Drive the machine to the work unit until the quick-change unit (3) is below the pickup hooks of the work unit. Then, lift the boom until the work unit catches the quick-change unit. 7. Tip in the quick-change unit until the work unit is connected to the limit stops on the the quick-change unit by setting the multi-function lever into position ‘E’ (fig. G0065021.eps). 8. Lock the quick-change unit by setting the control lever for special equipment into position ‘2’ (fig. G0065018.eps). The interlocking pins (4) will then be visible (fig. 75_280). If the work unit is not properly attached, it can suddenly fall down and cause severe accidents!
Carefully lift the work unit and check whether it is completely locked in by tipping it in and then dumping it. 9. Check whether the work unit is completely locked by tipping it in and then dumping it. 3-70 WA90-5 – VEAM270100 3 4 75 280 _ WARNING WARNING