00-24 POWER TAKE OFF Legend 1. Oil pump 2. PTO 3. Direction of forward rotation 4. Direction of backward rotation 5. Shaft (drive shaft) Cable Adjustment (Dump Lever Side) If a defect is found as a result of the inspection of the aforementioned items (1) to (3), adjust the control cable in the dump lever portion inside the cab according to the following procedure. 1. Set the dump lever to the “Down” position. 2. Loosen the lock nut of the control cable and adjust the cable as follows: NPA0053E Legend 1. Oil pump 2. Spool extrusion 3. After adjustment, tighten the lock nut at a specified torque. Tighten:
Lock nut to 6 N m (0.6 kg m / 52 lb in) Notes on Replacing and Adjusting Control Cable for Three-rotation Dump Truck 1. The control cable between the “Dump lever and se- lector” of the three-rotation dump truck is manufac- tured by ISUZU MOTORS LIMTED. This control cable is sent for (at replacement) in the Isuzu Motors Service Network, and because the selector need be disassembled, assembled, and adjusted, request a service network (SS store) of a body manufacturer of the replacement work. 2. The selector main unit for the three-rotation dump truck and the control cable between the “Selector and PTO (with oil pump) are manufactured by a body manufacturer.
Request a service network (SS store) of a body manufacturer of the replacement work of the selec- tor main unit and the aforementioned control cable. 3. First adjust the control cable at the dump lever bot- tom, adjust the control cable in the cable holder portion of the PTO (oil pump portion), and check that the shaft (driving shaft) of the oil pump will not rotate concurrently. Then because the adjustment of the selector main unit is necessary (only at down lever down, the ejection direction of the cargo deck can be selected. If this adjustment is improper, the cargo deck may fall off.), request a service network of a body manufacturer of the adjustment. NPA0052E Legend 1. Squeeze 2.
Pull out 3. Dump cable 4. Dump lever 5. Loosen When the rise time is improper or when the shaft is in- verted at “Down” time or when the dump lever is hard to lock at “Down” time, move the inner cable to Direction (1) of the drawing. When the fall time is improper or when the dump lever is hard to lock at “Up” time or when the shaft rotates for- ward at “Down” time, move the inner cable to Direction (2) of the drawing. Notice: If the cable is adjusted on the dump lever side, be sure to re-inspect the amount of spool extrusion.