00-28 POWER TAKE OFF Legend 1. Control cable 2. Boss portion 3. Lock nut Control Cable Adjustment (Dump Lever Side Inside Cab) 1. Operate the dump lever twice or three times with the engine in the stopped state and slowly set it to the “Up” position, then firmly lock the dump lever. 2. Measure the length “L1” on the control cable tip and double nut side shown in the drawing and check that it is within the following basic value. Length “L1”: 14 ± 1 mm (0.55 ± 0.039 in) 3.
As a result of measurement, if the length “L1” does not satisfy a basic value, loosen the lock nut and adjust the control cable so that the length “L1” will be set to a specified length “L1”, then tighten the lock nut at a specified torque. NPA0059E Legend 1. Bolt 2. Shift cap 3. Make groove face downward 4. Truck front Tighten: Lock nut to 6 N m (0.6 kg m / 52 lb in) Adjustment of the Amount of Spool Extrusion (Control Cable Adjustment) Notice:
As a result of the “Measurement of The Amount of Spool Extrusion” described previously, if a specified extrusion dimension cannot be obtained, adjust the control cables on the dump lever side inside the cab and the dump le- ver side according to the following procedure. NPA0061E Legend 1. Lock nut 2. Double nut 3. Control cable Control Cable Adjustment (Oil Pump Side) 1. Tighten the special nut in the cable holder loosen- ing the lock nut, moving it to the truck rear, and lightly pushing the control cable against the PTO side. 2. Measure the length “L2” between the outer screw tip portion and special nut end of the control cable shown in the drawing and check that it is within a basic value.
Length “L2” (Reference): 24 +1 0 mm (0.945 +0.039 0 in) NPA0060E As a result of check, if the length “L2” is satis- fied, tighten the lock nut at a specified torque.