POWER TAKE OFF 00-37 Legend 1. Push in 2. Pull out 3. Dump cable 4. Dump lever 5. Loosen 9. Shift Cap 10. Bolt (Shift Cap) Install the shift cap in the oil pump making its grooved side face upward and tighten the bolt at a specified torque. Tighten: Shift cap bolt to 24 N m (2.4 kg m / 17 lb ft) Notice: If the groove is not installed facing downward, the water intruded in the shift cap is not ejected but collected. Rusting and freezing will cause an incorrect actuation. NPA0071E Legend 1. Oil pump 2. Bolt 3. Shift cap Supply and Air Bleeding of Hydraulic Operating Fluid After having installed the oil pump, supply hydraulic op- erating fluid and release air as requested.
Supply the hy- draulic operating fluid and release air in accordance with the “Inspection and Supply of The Hydraulic Operating Fluid” and the “Air Bleeding Procedure of Hydraulic Op- erating Fluid” described previously.