00-42 POWER TAKE OFF After having adjusted the control cable and having inspected or adjusted the amount of spool extrusion, tighten the bolt and the special nut and lock nut of the control cable at a speci- fied torque. Tighten: Bolt to 24 N m (2.4 kg m / 17 lb ft) Special nut to 147 N m (15 kg m / 108 lb ft) Lock nut to 20 N m (2.0 kg m / 14lb ft) NPA0071E Legend 1. Oil pump 2. Bolt 3. Shift cap 10. Drain Plug, Filler Plug Firmly tighten the drain plug of the transmis- sion. NPA0094E Supply the transmission oil (BESCO gear oil transaxle (5W-30) or equivalent) until it flows out from the filler plug hole and firmly tighten the filler plug. Amount of Oil (Reference) 5 speed:
3.2 Liters (0.85 US gal / 0.70 Imp. gal) 6 speed: 4.0 Liters (1.06 US gal / 0.88 Imp. gal) Legend 1. Bolt 2. Lock nut 3. Special nut 8. Shift Cap 9. Bolt (Shift Cap) Tighten: Drain plug and filler plug to 49 N m (5.0 kg m / 36 lb ft) Install the shift cap in the oil pump making its grooved side face upward and tighten the bolt at a specified torque. Supply and Air Bleeding of Hydraulic Operating Fluid Tighten: Shift cap bolt to 24 N m (2.4 kg m / 17 lb ft) After having installed the oil pump, supply hydraulic op- erating fluid and release air as requested.
Supply the hy- draulic operating fluid and release air in accordance with the “Inspection and Supply of The Hydraulic Operating Fluid” and the “Air Bleeding Procedure of the Hydraulic Operating Fluid” described previously.