POWER TAKE OFF 00-41 NPA0089E NPA0073E Legend 1. Oil pump 2. PTO 3. Bolt Legend 1. Low-pressure hose 2. High-pressure hose 3. High-Pressure Hose 5. Control Cable 6. Cable Holder 7. Bolt (Cable Holder) Install the high-pressure hose in the oil pump and firmly tighten the joint. Notice: Install the control cable and cable holder in the PTO in accordance with Items 1 to 4 of “Installation” in the “Re- moval and Installation of Control Cable for Rear Dump Truck”, and after installation inspect and adjust it in ac- cordance with the “Amount of Spool Extrusion”. Notice:
When the PTO (with oil pump) is installed in the high- pressure hose rotating the PTO in Item 10 described previously, firmly tighten the joint. 4. Low-Pressure Hose Install the hose and firmly tighten the hose band. Notice: When installing the high-pressure hose and the low- pressure hose, be fully careful so that dust or foreign matter will not be mixed in the pose port and the oil pump. NPA0072E Legend 1. Cable holder 2. PTO 3. Bolt 4. Control cable