1. Clock/Engine Hour Meter - The clock function indicates time in the 12-hour mode; the hour meter indi- cates the total time the ATV has run and cannot be reset to zero. To set the clock, use the following proce- dure. NOTE: High engine RPM, low vehicle speed, or heavy load can raise engine temperature. Decreas- ing engine RPM, reducing load, and selecting an appropriate transmis- sion gear can lower the tempera- ture. A. With the ignition switch ON, press and release the Mode But- ton (3) until the Clock/Engine Hour Meter (1) is displayed; then (if necessary) press and release the Set/Reset Button (4) to select the clock display. NOTE:
Debris in front of the engine (or packed between the cooling fins of the radiator) can reduce cooling capacity. Using a garden hose, wash the radiator and the engine to remove any debris restricting air flow. B. Press and hold the Set/Reset Button (4) until the minutes stop scrolling and the hour display starts to scroll. Momentarily release when the correct hour is displayed; then repeatedly press and release the Set/Reset Button (4) until the correct minutes are displayed. NOTE: Clock memory power is supplied through the 15-amp acces- sory fuse and verified during gauge “power-up” and reset.
In the event of clock memory power failure (blown fuse, etc.), the gauge will “power-up,” reset, and shut down repeatedly until clock memory power is restored. Always check the 15-amp accessory fuse if this gauge condition is noted. after the Mode Button is released, the digital gauge will return to full display. NOTE: The engine hour meter will not activate until engine speed exceeds 500 RPM. 4. Set/Reset Button - In conjunction with the Mode Button, sets and resets various displays on the digital gauge. Also used to shift from speedometer function to tachometer function on the speedometer/ tachometer gauge. 2.
Temperature Indicator - If the engine coolant temperature exceeds the nor- mal operating range, the temperature icon will begin flashing and the LCD will go blank for 30 seconds; then the LCD will return to normal. However, the temperature icon will continue to flash. 5. Fuel Level Indicator - Indicates approximate amount of gasoline in the gas tank. NOTE: When the bottom segment flashes, approximately 3.5 L (0.92 U.S. gal.) of gasoline remains in the tank. CAUTION Continued operation with high engine temperature may result in engine damage or premature wear. 41 41 41 41 CAUTION Arctic Cat does not recommend using a pressure washer to clean the radiator core.
The pressure may bend or flatten the fins causing restricted air flow, and electrical components on the radiator could be damaged. Use only a garden hose with spray nozzle at normal tap pressure. Division II - Operation/ Maintenance 3. Mode Button - Shifts the gauge through three set-up modes: speed- ometer/tachometer, distance, and time. NOTE: The Mode Button must be pressed and released to shift modes. Approximately two seconds