6. Low Oil Pressure - Will be displayed during self-test at start-up. It will not be displayed during normal opera- tion as oil pressure is not monitored on these models. A. Volt - The LCD will go blank except the word VOLT will flash on the LCD whenever a low voltage ( high voltage (> 16 DC volts) is detected. When voltage returns to normal, the gauge must be reset by turning the ignition key to the OFF position and then to the ON position. 7. Odometer/Trip Meter - Odometer registers the total distance the vehi- cle has traveled. The trip meter is resetable and can be used to measure trip or trip legs. The odometer can- not be reset. NOTE:
To shift between the odometer (ODO) or trip meter (TRIP), press the Mode Button (3) to select the distance mode; then press the Set/Reset Button (4) to select the desired display. Hold the Set/Reset Button down to reset the trip meter. B. EFI - The LCD will go blank except a diagnostic trouble code (DTC) will flash on the LCD and a wrench icon will be dis- played whenever an electronic fuel injection malfunction is detected. After 30 seconds, the LCD will return to normal; however, the DTC and wrench icon will continue to be dis- played until the malfunction is corrected. 8. Gear Position Indicator - Indicates which gear position is selected.
R (reverse)/N (neutral)/L (low range)/ H (high range) NOTE: An E will be displayed if there is an error caused by a no- shift position signal. NOTE: Take the ATV to an autho- rized Arctic Cat ATV dealer to have the EFI error corrected and to have the ECU reset as soon as possible. 9. High Beam Indicator - The High Beam icon will appear only when the headlights are on high beam. Primer - Cold Start (350) 10. Drive Select Indicator - Displays 4WD when selected by the drive select switch. The display is blank when in 2WD. 11. Speedometer - Indicates the approxi- mate vehicle speed in miles per hour (MPH) or kilometers per hour (km/ h). NOTE:
To change mph/km/h dis- play, press and release Mode But- ton (3) until the icon (MPH/km/h) appears; then press the Set Button (4) to change the display. CF123A The primer is located on the carburetor. Depress and release the lever several times prior to attempting to start a cold engine. Gas/Vent Hoses Replace the gas hose every two years. Damage from aging may not always be visible. Condition Warning Display (425) - Uses odometer/trip meter display of the LCD to warn of a system error condition requiring attention. On the 350, do not bend or obstruct the routing of the carburetor vent hose.
Make certain that the vent hose is securely con- nected to the carburetor and hose holder and the opposite end is always open. 42 42 42 42