00 Prepare replacement parts ready for installation. Oil seals, packings, O-rings and other rubber parts, gaskets, and split pins must be replaced with new ones after removal. Use only genuine MITSUBISHI replacement parts. When disassembling parts, visually check them for wear, cracks, damage, deformation, deterioration, rust, corrosion, defective ro- tation, fatigue, clogging and any other possible defect. separately. Apply the specified oil or grease to U-seals, oil seals, dust seals and bearings before reassembly. Always use the specified oils and greases when performing in- spection or replacement. Immediately wipe away any excess oil or grease with a rag. 00-9 CAUTION