TPD1317e Chapter 7 7.4 Interconnecting Cable Interconnecting cables (Figure 10) are used to join the engine loom to the instrument panel(s). Cables are made in 4, 6, 8, 10 and 12m lengths and all cables have a male plug (1) at one end and a female (2) at the other. Cables may be plugged together to give up to 12m length, but in general if a longer cable is required it should be ordered as a special item, to be made in one piece. A ‘Y’ harness (Figure 11) is available, with a male plug at (1) and two female plugs (2). If necessary, more than one ‘Y’ harness may be used, to connect several instrument panels together, in any of the combinations shown on Figure 15.
Details of the plugs and sockets, and the wiring of the ‘Y’ harness are shown on Figure 11. Figure 10 - Interconnecting cable Figure 11 - ‘Y’ harness Page 45