Ch 2 page 155 TRANSMISSION Install the end plate (1) and fasten the disc set with snap ring (2). Installation position of end plate (1) Carry out the next step referring to disc clearance check operation See “Figure 536” on page 174 and “Figure 537” on page 174 Figure 462 Heat up the internal teeth of the clutch (1) (approx. 120° C). Figure 463 Assemble the clutch (1) until contact. WARNING Use safety gloves! Adjust the clutch after cooling down! Figure 464 Engage snap ring SB 72 (1) into the recess. Figure 465 SHOP MANUAL CAUTION