TRANSMISSION Ch 2 page 156 Heat up the internal teeth of the gear (approx. 120° C). Figure 466 Assemble the gear (1) until the snap ring has engaged into the recess of the gear. NOTE Both ends of the snap ring must be located in one of the four mounting holes (see arrows)! The snap ring must be engaged into both recesses of shaft and gear! Use safety gloves! Figure 467 Heat up the bearing inner ring of the taper roller bearing (approx. 120° C). Figure 468 Assemble the bearing inner ring (1) until contact. WARNING Use safety gloves! Adjust the bearing inner ring after cooling down! Figure 469 SHOP MANUAL WARNING CAUTION