TRANSMISSION Ch 2 page 182 Installation input shaft and clutches Housing II Mount the O-rings 11x3 (1) onto the connection socket of the pipe (2) and grease them. Figure 565 Insert the oil pipe (1) into housing II and fasten it by means of the cylindrical screws (2). Tightening torque (M8/8.8x16) MA = 23 Nm Figure 566 Install all oil pipes as described in Figure 566. Figure 567 Fasten wiring harness Ergopower II L by means of clips (1) and strap (2) with the cylindrical screws in housing II. Tightening torque (M6/8.8x12) MA= 9.5 Nm Fasten wiring harness L II by means of cable binders (3) additionally. Figure 568 SHOP MANUAL