Ch 2 page 183 TRANSMISSION Snap ring SP 62 (see arrow) must snap into the recess. Expand snap ring and assemble ball bearing 35x62x14 until snap ring has snapped into groove of the ball bearing. Heat up bearing inner ring of ball bearing (approx. 120° C). Risk of injury! Figure 569 Install the input gear of the emergency steering pump into the ball bearing until contact is obtained. Figure 570 Axially fix the input gear (1) by means of retaining ring 35x1.5 (2). Legend:
1 = Input gear emergency steering pump 2 = Retaining ring 35x1.5 3 = Ball bearing 35x62x14 4 = Snap ring SP 62 Figure 571 By means of a suitable pressure piece install the ball bearing 75x130x25 (1) into transmission housing II until contact is obtained and lock it with the retaining ring 130x4 (2). Figure 572 SHOP MANUAL WARNING