TRANSMISSION Ch 2 page 204 Engine connection Install the shaft seal by means of the driver tool (S), with the sealing lip showing to the oil sump. Wet outer diameter (rubber coated) with spirit and grease the sealing lip! Shaft seal 135x170x12 (S) Driver tool 850317-00090 Figure 646 Instalation position is on the shaft seal. See Figure 647 NOTE Exact installation position is obtained when using the specified driver tool (S)! Legend: 1 = Shaft seal 135x170x12 2 = Converter bellhousing 3 = Pressure pipe (cooler recirculation) Figure 647 Mount two adjusting screws and install the converter bellhousing until contact. (S) Adjusting screw 120702-00080 Figure 648 Install the pins 10x36 (1).
Fasten the converter bellhousing by means of cylindrical screws (2 and 3). Tightening torque (M10/8.8x30) MA = 46 Nm Tightening torque (M10/8.8x85) MA = 46 Nm Figure 649 SHOP MANUAL