Ch 2 page 215 TRANSMISSION Mount the O-ring 350x5 (1) and grease it. Check closing and opening of the clutch by means of compressed air at the hole (see arrow). Closing and opening of the clutch must be clearly audible. Figure 690 Mount planetary drive to housing II Insert the compression springs Insert the compression spring 24x3.5 with grease into the recess. Figure 691 Turn in the eyebolt until contact. (S) Eyebolt 850317-00070 Figure 692 By means of the lifting tackle insert the planetary drive (1) into the disc carrier of clutch ”E“ and install it on housing II until contact. Drive the slotted pins 12x30 (2) into housing II until contact.
(S) Adjusting screws 120702-00080 Figure 693 SHOP MANUAL NOTE