TRANSMISSION Ch 2 page 216 Fasten the planetary drive with the cylindrical screws (1). Tightening torque (M10/8.8x50) MA = 46 Nm Figure 694 Turn the drain bolt (1) with Ѕ“ extension and long socke wrench SW19 into the shaft of clutch ”E“ and hand-tighten it. Figure 695 Assemble the pressure piece (S) onto the extension and tighten it by means of an open end wrench (for tightening of the strain bolt the planetary drive is held in place). Tighten the strain bolt. Tightening torque MA = 62 Nm (S) Pressure piece 850317-00092 Figure 696 Install the screw plug M33x2 with O-ring 30x2.5 (1). Figure 697 SHOP MANUAL