SRS fault indicator lamp SRS fault indicator lamp located on the instrument cluster will alert the driver that the airbag system is faulty. When the start/stop button is in "RUN" mode, the warning lamp will be on for a few seconds for system self-check and then off. Maintenance and scrapping of airbag Front frontal airbag The parts of airbag system are installed in different positions of the vehicle.
Any operation of the airbag system or disassembly of the airbag system components due to maintenance of other parts of vehicle must be carried out by professional technicians, otherwise the airbag system may be damaged, resulting in abnormal triggering of the airbag system or no triggering at all in the event of an accident. If the following phenomena appear, it means that the airbag system is faulty. At this time, the airbag and seat belt pretensioner may not work normally in the event of a collision. Please go to BAIC Motor Dealership for inspection in time: Safe Operation Instructions The driver's frontal airbag ① is located in the middle of the steering wheel.
The front passenger frontal airbag ② is located in the dashboard above the glove box. If the vehicle is scrapped, the undeployed airbag is potentially dangerous, so when the vehicle is scrapped, the airbag must be safely detonated by a professional. ● When the start/stop button is in the "RUN" mode, the SRS fault indicator lamp does not illuminate during the self-check of the instrument cluster system. The frontal airbag inflates when the vehicle is hit by a frontal violent impact, or it may inflate due to a similar impact (such as hitting a ditch on the road).
It may not deploy and expand in case of certain front collision (such as when the front of vehicle collides with fine columnar objects such as trunk and electric poles). The degree of damage to the vehicle is not a sufficient condition for the ● When the start/stop button is in the "RUN" mode, the SRS fault indicator lamp is always on. ● When the vehicle is running, the SRS fault indicator lamp turns on. 15 may seriously injure the driver and passengers. Do not attempt to repair, remove or install parts of airbag system yourself. If the airbag system is repaired by non-professional personnel, the potential risk of injury or death will be increased.
If the airbag system is maintained improperly, in the event of an accident, the airbag may not deploy or may deploy when it should not. Do not attempt to retrofit the front bumper or the body structure by yourself. The airbag can only be triggered once, and the whole airbag system component must be replaced after triggering. When cleaning the steering wheel or dashboard, do not use solvent-based cleaning agents, otherwise, embrittlement deformation may occur on the surface materials of these components. Once the airbag is triggered, the broken plastic