OPERATION SECTION 1 Page 21 SPEED CONTROL LEVER STOPPER This stopper prevents the speed control lever from entering the 3rd and 4th positions, when working. Position 1 Stopper actuated. Position 2 Stopper released. STEERING COLUMN TILT LEVER This lever allows the steering column to be tilted forward or backward. Pull the lever up and move the steering wheel to the desired position. Then push the lever down to lock the steering wheel in position. * Range of adjustment: 100 mm (stepless) WARNING! Stop the machine before adjusting the angle of the steering wheel. ACCELERATOR PEDAL This pedal controls the engine speed and output.
The engine speed can be freely controlled between low idling and full speed. BRAKE PEDALS The right brake pedal operates the wheel brakes, and is used for normal braking. Right brake pedal WARNINGI When traveling downhill, use the engine as a brake, and always use the right brake pedal. The left brake pedal operates the wheel brakes, and if the transmission cut-off selector switch is at ON, it also returns the transmission to neutral. Left brake pedal If the transmission cut-off selector switch is at OFF, the left brake pedal acts in the same way as the right brake pedal. A WARNING! Do not use the brake pedals repeatedly unless necessary. A WARNINGI Do not use the brake pedals as footrests.
Use them only when applying the brakes. * When the accelerator is being used for operating the work equipment. always use the left brake pedal to slow or stop the machine after putting the transmission cut-off selector switch in ON.