SERIES 60 SERVICE MANUAL 16. Disconnect the fuel inlet and outlet lines at the rear of the cylinder head. See Figure 1-33. Figure 1-33 Removing Fuel from Cylinder Head Internal Passages EYE INJURY To avoid injury from flying debris when using compressed air, wear adequate eye protection (face shield or safety goggles) and do not exceed 276 kPa (40 psi) air pressure. 17. Blow low pressure compressed air into the inlet fitting for 20 to 30 seconds or until all of the fuel is purged from the cylinder head. 18. Disconnect the injector wire harness at each injector. Refer to section 2.3.2. 19.
Remove the harness mounting flange from the rear of the cylinder head and carefully remove the harness from the head by pulling the harness through the hole in the cylinder head. See Figure 1-25. All information subject to change without notice. (Rev. 2005) 6SE483 0507 Copyright © 2005 DETROIT DIESEL CORPORATION 1-43