1.2 CYLINDER HEAD NOTICE: To avoid possible damage to the injector spray tips, remove the injectors before lifting the head from the block. If the injectors are not removed, handle the head carefully when it is off the block and support the head fire deck on wooden blocks. 20. Remove the fuel injectors. Refer to section 2.3.2. NOTE: Fuel must be removed from the cylinder head fuel galleries prior to removing the injectors. 21. Remove the gear case stabilizer bracket at the right and/or left front corner of the head. 22. Remove the head bolts and install the cylinder head lifter bracket (J–35641–A) using the bolt hole at the inboard center, No. 3 cam cap and two tapped Jake Brake® bolt holes.
See Figure 1-34. Figure 1-34 Cylinder Head Lift Bracket Removal (Rev. 2005) All information subject to change without notice. 1-44 6SE483 0507 Copyright © 2005 DETROIT DIESEL CORPORATION