Basic components 3. Selector switch (for fuel sensor) EMU26610 Trim meter This gauge shows the trim angle of your out- board motor. 1. Speedometer 2. Fuel gauge 3. Trip meter/clock/voltmeter 4. Warning indicator(s) ZMU04581 NOTE: After the main switch is first turned on, all segments of the display come on as a test. After a few seconds, the gauge will change to normal operation. Watch the gauge when turning on the main switch to make sure all segments come on. NOTE: Memorize the trim angles that work best for your boat under different conditions. Adjust the trim angle to the desired setting with the power trim and tilt switch. NOTE:
The speedometer displays km/h, mph, or knots, according to operator preference. Se- lect the desired unit of measurement by set- ting the selector switch on the back of the gauge. See the illustration for settings. EMU26620 Trim meter (digital type) This meter shows the trim angle of your out- board motor. NOTE: G Memorize the trim angles that work best for your boat under different conditions. Adjust the trim angle to the desired using the power trim and tilt switch. G If the trim angle of your motor exceeds the trim operating range, the top segment on the trim meter display will blink. 1. Cap 2. Selector switch (for speed unit) 18