Basic components EMU26690 Trip meter This gauge displays the distance the boat has traveled since the gauge was last reset. Press the “ ” (mode) button repeatedly until the indicator on the face of the gauge points to “ ” (trip). To reset the trip meter to zero, press the “ ” (set) and “ (mode) buttons at the same time. ZMU01869 EMU26650 Hour meter (digital type) This meter shows the number of hours the engine has been run. It can be set to show the total number of hours or the number of hours for the current trip. The display can also be turned on and off. NOTE: G The trip distance is shown in kilometers or miles depending upon the unit of measure- ment selected for the speedometer.
G The trip distance is kept in memory by bat- tery power. The stored data will be lost if the battery is disconnected. ZMU01870 G Changing the display format EMU26700 Clock Press the “ ” (mode) button repeatedly until the indicator on the face of the gauge points to “ ” (time). To set the clock, be sure the gauge is in the “ ” (time) mode. Press the “ ” (set) button; the hour display will begin blinking. Press the “ ” (mode) button until the desired hour is displayed. Press the “ ” (set) button again, the minute display will begin blinking. Press the “ (mode) button until the desired minute is dis- played. Press the “ ” (set) button again to start the clock.
G Pressing the “ ” (mode) button chang- es the display format in the following pat- tern: G Resetting the trip hours G Total hours Trip hours Display off G Simultaneously pressing the “ ” (set) and “ ” (mode) buttons for more than 1 second while the trip hours are displayed resets the trip counter to 0 (zero). NOTE: The total number of hours the engine has been run cannot be reset. 19