OM2030 Safety - Section 20 Page 20-9 When Dumping Before starting the dumping operation, check that there is no person or objects behind the machine. Stop the machine in the desired location. Check again for persons or objects behind the machine. Give the determined signal, then slowly operate the dump body. If necessary, use blocks for the wheels or position a flagman. When dumping on slopes, machine stability is poor and there is danger of tip over. Always perform such operations using extreme care. Never travel with the dump body raised. Working On Loose Ground Avoid operating the machine near cliffs, overhangs, and deep ditches.
If these areas collapse, the machine could fall or tip over and result in serious injury or death. Remember that ground surfaces in these areas may be weakened after heavy rain or blasting. Freshly laid soil and the soil near ditches is loose. It can collapse under the weight or vibration of the machine. Avoid these areas whenever possible. When Loading Check that the surrounding area is safe, stop the machine in the correct loading position, then load the body uniformly. Do not leave the operator's seat during the loading operation. Parking The Machine Choose a horizontal road surface to park the machine.
If the machine has to be parked on a slope, always put blocks under all the wheels to prevent the machine from moving. When parking on public roads, provide fences and signs, such as flags or lights, on the machine to warn pedestrians and other vehicles. Be sure that the machine, flags, or lights do not obstruct the traffic. Before leaving the machine, lower the dump body fully, activate the parking brake, stop the engine, and lock everything. Always take the key with you. TOWING When Towing, Fix Wire To Hook Improper towing methods may lead to serious personal injury and/or damage. Use a towing device with ample strength for the weight of this machine. Never tow a machine on a slope.
Do not use tow rope that has kinks or is twisted. Do not stand astride the towing cable or wire rope. When connecting a machine that is to be towed, do not allow anyone to go between the tow machine and the machine that is being towed. Set the coupling of the machine being towed in a straight line with the towing portion of the tow machine, and secure it in position. (For towing methods, refer to Section 30, Operating Instructions - Towing.)