n 2 0 OM2030 A r c e w f c k c o t c m n t r ay a o IN ize hm pre r T er orm k t un hin r g ma s in un or o e te o ou w y pu T d e v h a i h d e re c t e s m ca r e g a w ls EN per nts ent t e M ll m ng s e tir er t Cle ase hine o th xpe team part re the nter h an ter i ater ion. s t h a o e e h , c e ct m w c t y n i ANCE onnel can service and repair the machine. hat have been removed from the machine in a safe place and em from falling. chine vable work equipment to the ground or to their lowest position rvice or repairs under the machine. s of the machine securely. e machine if the machine is poorly supported. an scattered tools, etc. can cause you to slip or trip. Always lean and tidy.
electrical system, there is danger that the machine may edly and/or damage to components may occur. Do not to clean any sensors, connectors, or the inside of the ent. hen washing the electrical control cabinet. Do not allow ontrol cabinet around the doors or vents. Do not allow he cooling air inlet duct above the electrical control cabinet. If water enters the control opening or crevice) major damage to the electrical components is possible. to the rear wheel electric motor covers. Damage to the wheel motor armatures may occur. nto the retard grids. Excess water in the retard grids can cause a ground fault, which will Adding Fuel Or Oil ay cause slipping. Always clean up spills, immediately.
p of the fuel and oil fillers securely. sh parts. oil in a well-ventilated area. ys ay ot e w t abinet around the doors or vents. Do not allo ng air inlet duct above the electrical control g or crevice) major damage to the electrical co ar wheel electric motor covers. Damage to the etard grids. Excess water in the retard grids c w g air inlet duct above the electrical control or crevice) major damage to the electrical co r wheel electric motor covers. Damage to the tard grids. Excess water in the retard grids c c m a abinet. If water enters the control ponents is possible. wheel motor armatures may occur.
n cause a ground fault, which will Rules To Follow When Adding • Spilled fuel and oil may caus • Always tighten the cap of the • Never use fuel to wash parts • Always add fuel and oil in a w Rules To Foll • Spilled fue • Always tig • Never use o l h f w an ten ue W d t l t hen oil he c o w m a a Adding ay caus p of the sh parts F e f . uel Or Oil slipping. Always clean up spills, immediately uel and oil fillers securely. . • Always ad d fu e l and oi ell-ventilated area.