Assembly Procedure PC8000 Space and Placing Requirements On the following page, the components are indicated in their approximate dimensions. They are unloaded in a way that a min. space of 1 meter (3 ft) is left between the components, and that there is enough space for the trucks and the cranes. Preparation for Assembly Unload all components so that no more move is necessary! All pins, bushings, borings, bearings and contact surfaces of components must be clean. Torque values are listed in the Lubrication- and Maintenance Manual - unless being listed in this Assembly Procedure Booklet. Obey all applicable safety and local regulations strictly!
Ensure correct lifting procedures and ensure use of adequate lifting gears! High voltage installation works must be carried out by authorized specialists only. PC8000AS rev 02.doc 15 Edition 01/2004