Assembly Procedure: Komatsu PC8000 Hydraulic Mining Shovel (EN)

General Assembly Procedure Hydraulic Mining Shovel PC8000 _______________________________________________________________________________ _______________________________________________________________________________ PC8000AS rev 02.doc 1 Edition 01/2004

Стр. 1

Assembly Procedure PC8000 All stated information corresponds to the present development and is subject to possible future changes without prior notice. PC8000AS rev 02.doc 2 Edition 01/2004

Стр. 2

Assembly Procedure PC8000 Delivery of the Excavator The excavator is being delivered disassembled into its main components. For assembling the excavator follow the instructions in this manual. Various bolts used e.g. for transport security, blanking plates etc. will be re- used during final assembly. Please take out small parts stored in the cab refrigerator. Symbols г WARNING Refers to orders and prohibitions designed to prevent injury or extensive damage. г Personnel entrusted with work on the machine must have read the Assembly Manual, the Operation,- Lubrication- and Maintenance Manual and in particular the section on safety before beginning work.

Reading the instructions after work has begun is too late. If there are any questions concerning the assembling procedure, contact your local Service Center. Prior to first operation, inspect the excavator thoroughly with the Service Engineer responsible for the erection of the machine. Check all fluid levels according to the Lubrication and Maintenance Schedule. Damages and defects caused by incorrect operation and maintenance are not covered by the manufacturers guarantee. ) If the excavator is equipped with a fire suppression system, make sure that the system is ready for operation. Service For all questions related to your excavator please contact your local Service Center.

In all your written or phoned inquiries please indicate the model and serial number of your excavator. PC8000AS rev 02.doc 3 Edition 01/2004

Стр. 3

Assembly Procedure PC8000 PC8000AS rev 02.doc 4 Edition 01/2004

Стр. 4